Hydraulic vane motors fixed displacement
Motor LMC M100, is of the type to vanes of fixed, bidirectional displacement, balanced construction. The operation can be continuous or intermittent in both senses of rotation. When circuíto this provided with protection by safety valve the motor can be used for reversible cycle.
General data (Click to expand)
)
Model
Entrance of fluid by A: right
Entrance of fluid by B: Left
The load does not have to be supported by the bearings of the motor and it connects recommendable between both is direct, coaxial and the flexible one.
The connection is external, it does not have to be restricted and it must be connected to the deposit below the inner level of the possible fluid.
Normally it is 400 RPM, speeds but low they are permissible depending on the requirement of torque.
to see table
to see table
to see characteristics curves.
65% (minimum) of torque to 400 RPM.
Technical data
Curve
Model code
Motor LMC M200, is of the type to vanes of fixed, bidirectional displacement, balanced construction. The operation can be continuous or intermittent in both senses of rotation. When circuíto this provided with protection by safety valve the motor can be used for reversible cycle.
Drainage is internal, there is no connection with the tank.
General data (Click to expand)
)
Model
The load does not have to be supported by the bearings of the motor and it connects recommendable between both is direct, coaxial and the flexible one.
Motors are build for right rotation, if left rotation is required, specify it.
Installation position is different.
Normally it is 100 RPM, speeds but low they are permissible depending on the requirement of torque.
to see table
to see table
to see characteristics curves.
65% (minimum) of torque to 400 RPM.
Technical data
Curve
Shaft options
(Click to expand)
)
Model code
Motor LMC M25, is of the type to vanes of fixed, bidirectional displacement, balanced construction. The operation can be continuous or intermittent in both senses of rotation.
When circuit this provided with protection by safety valve the motor can be used for reversible cycle.
General data (click to expand)
)
Model
Entrance of fluid by A: right
Entrance of fluid by B: Left
The load does not have to be supported by the bearings of the motor and it connects recommendable between both is direct, coaxial and the flexible one.
The connection is external, it does not have to be restricted and it must be connected to the deposit below the inner level of the possible fluid.
Normally it is 400 RPM, speeds but low they are permissible depending on the requirement of torque.
to see table
to see table
to see characteristics curves.
65% (minimum) of torque to 400 RPM.
Technical data
Curve
Shaft option
)
Model code
